FS: TFS tunnel ram intake and pushrods
Page 1 of 1
FS: TFS tunnel ram intake and pushrods
I have a TFS tunnel ram intake, coverted to EFI. It has 3 injector bungs per cylinder. Was going to use it in a different car, but will not fit in the new car. Never been run or ported. Can easily weld up injector bungs and use for carbs. Make me an offer (a decent one anyway). Have pics, will try to post tomorrow.
1 set of pushrods. Was set up for my 598, but I mismeasured. Here are the specs. Trend custom P/R's. Intake: 9.175", 9/16" diameter, .187" wall, 5/16" ball, 1 5/8" taper on each end. Exhaust: 9.575", 9/16" diameter, .187" wall, 5/16" ball, 1 5/8" taper on each end. These were bought for a 598, TFS A460 headed motor. Can give more specs if needed. I paid $500 even for them, and I have 9 Exh, and 9 Int. Make me a decent offer.
Ryan
rchapman@tadano-cranes.com
1 set of pushrods. Was set up for my 598, but I mismeasured. Here are the specs. Trend custom P/R's. Intake: 9.175", 9/16" diameter, .187" wall, 5/16" ball, 1 5/8" taper on each end. Exhaust: 9.575", 9/16" diameter, .187" wall, 5/16" ball, 1 5/8" taper on each end. These were bought for a 598, TFS A460 headed motor. Can give more specs if needed. I paid $500 even for them, and I have 9 Exh, and 9 Int. Make me a decent offer.
Ryan
rchapman@tadano-cranes.com
chappy89- Posts : 95
Join date : 2009-08-26
Location : Houston, TX
Similar topics
» Kaase pushrods - intake and exhaust - 9.050 and 8.850 long
» 3/8" PUSHRODS and New E7TZ-6507-D intake valves
» Tunnel ram intake
» new never used trickflow a460 tunnel ram single carb top plate ....looking to trade
» NEW Weiand 2x4 Tunnel Ram Intake 429-460
» 3/8" PUSHRODS and New E7TZ-6507-D intake valves
» Tunnel ram intake
» new never used trickflow a460 tunnel ram single carb top plate ....looking to trade
» NEW Weiand 2x4 Tunnel Ram Intake 429-460
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum