sold!!

Hi guys, selling my bbf set-up as going a different direction. I have a D1VE block bored .030 with keith black flat tops, stock rods with arp bolts, stock crank, Howards solid flat tappet camshaft, HV oil pump, fox body pan and mounts, Brand new set of FRPP Kaase design SCJ aluminum heads with gasket matched and cleaned up, less than 30 miles on them and yes the pistons were cut for these heads. New head specific HS rocker arms, along with 3/8ths chromeoly pushrods, Victor 460 4500 intake, MSD billit dizzy with wires and new billit aluminum pullies. Motor has less than 1500 miles on it since build but heads and valve train have less than 30 miles. Runs very strong and can here run before sale. complete engine minus carb as it is borrowed from friend. Also will sell the C-6 trans with 3500 stall and hooker super comp headers with 3 inch exaust and Morosso race bullit mufflers with header evac kit installed for fox body, brand new pipe and mufflers. $3500 for motor $600 for trans and converter and $450 for full exaust. Very nice looking engine also, intake is powdercoated black and tall aluminum valvecovers are powdercoat silver metalic.

will sell everything listed as a package for $4200. complete set-up for fox body mustang motor,trans w/converter,full exaust system

would you sell just the headers and mounts?

would like to talk about your stuff darren 405 413 3021

71torino wrote:would you sell just the headers and mounts?

only if someone bought just the engine, not pulling car apart until it sells.Thanks

strong runner here,good stuff.

Sounds like a good deal to me, if I didn't already have a BIG pile of parts I'd be all over this. Good luck with the sale.

Mike R wrote:Sounds like a good deal to me, if I didn't already have a BIG pile of parts I'd be all over this. Good luck with the sale.

thanks Mike, it does run and sound really good, leaving it in the car so buyer can see and here it run before I pull it which doesnt take long to do.

to the top

What kind of HP/Torque numbers are you looking at with this build?
Do you have any pics?
Is the c-6 tranny built as well?


Thanks, Ron

BroncoRon wrote:What kind of HP/Torque numbers are you looking at with this build?
Do you have any pics?
Is the c-6 tranny built as well?


Thanks, Ron

just going by the proven builds section, hp calculations, on this site it should be solidly between 550-600 hp and tq should be around 500ish with a good tune. Was never dynoed The trans was a rebuild with stronger spring for higher line pressure, will handle this power with no problem. Trans might be sold locally. Thanks
I can send pics to an email or cell phone for ya, I cant seem to figure how to upload to forum.

$4000 for engine,trans/converter, headers

pm sent

Pm me interested! New member cannot send msgs.

u have a pm

Ck&sons wrote:Pm me interested! New member cannot send msgs.

Sell just the Heads?