Profiler and C460 rocker arms

Do they use the same rocker arms?  Here is what I have.  Exhaust looks normal, intake is offset.  Same for the C460? Seeing how the profiler 205 is kind of regarded as the C460 replacement head, I am thinking yes--but I do know the intake port is raised .200 -- does that make any difference here?

does the C460 rockers and stands bolt on?
frank

I am not sure as i only have profilers, i dont have a pair of c heads. They bolt up to the profilers just fine.

whats the offset on the intake rocker? Post the letters stamped on the rocker

well I have 5 sets of C460's , with one set of heads with the jessels and 4 sets of heads and and 6 sets of the ford Crane rockers and the ford Crane are way stronger with bigger shafts
frank

letter stampimg on the jessels is EWHB85
frank

exhaust EAAS80
FRANK

Ok here is what I have:

The exhaust is FAAS80
The intake is EQGR80

Does the 80 mean they are 1.80 ratio?

80 = 1.80 ratio
pics of mine
RL=https://s58.photobucket.com/user/fmerkl/media/C460rockers001_zpsac74965c.jpg.html]" />[/URL]
on the left is my jeesels , on the right is the ford crane deal

Ok I found the rocker arm chart from Jesel in their online catalog. The letter code breakdown looks like this:

I'm going to save that chart ! good info!

some of the above measurements defined:

Frank Merkl wrote:well I have 5 sets of C460's , with one set of heads with the jessels and 4 sets of heads and and 6 sets of the ford Crane rockers and the ford Crane are way stronger with bigger shafts
frank

Frank,
Have you broken any of the Jesel stuff? Just curious as I have a Jesel setup also but only run a tad over 800 lift with a comp 948 triple spring and rpm the thing 7200.

Travis

to be honest I haven't ran the Jessel rockers yet as they can with my 632 that I Haven' ran as of yet
frank

The W+W Rockers that were on the other engine are the only thing I have to compare them with. Yhe shaft is definatley smaller on the Jesel, and my stands are 2 piece on the Jesel also where as the W+W were one piece, If I remember correctly the roller tip was also smaller in diameter by a smidge on the Jesel compared to the W+W. I had 200 passes on the Jesels and they were trouble free before sidelining the engine for a new project.

Interesting. Mine have 1 piece stands and they are Jesels.

psfracer wrote:Interesting.  Mine have 1 piece stands and they are Jesels.  

If it makes any difference I bought mine new in 2003 or 2004. Maybe something has changed in the last 10 years.

I would imagine so   

I'll get some pics of them also and post them too if you would like. Might be interesting to somebody else too.

Travis