ID for C6
4 posters
Page 1 of 1
ID for C6
hpwdboss1 February 10th 2014, 5:42 pm
Is there a way to positively determine {short of dis-assembly} what planetary setup is installed in a trans? I'm looking for a steel 2.71 low for a project and could purchase the parts loose, but I wouldn't mind a tear down to get one. That is, if I was sure what parts I'd get on completion. Thanks
Perry
Perry
hpwdboss1- Posts : 147
Join date : 2009-09-05
Age : 69
Location : Balbec Indiana
Re: ID for C6
Frank Merkl February 10th 2014, 8:06 pm
you won't find a steel 2.71 ratio in any C6 made
Frank
Frank
Frank Merkl- Posts : 1524
Join date : 2008-12-17
Age : 68
Location : Brooks ,Alberta ,Canada
id
hpwdboss1 February 10th 2014, 11:49 pm
Frank
So what has the steel 6 planet carrier been in? 'cause that's what is in mine now.
Perry
So what has the steel 6 planet carrier been in? 'cause that's what is in mine now.
Perry
hpwdboss1- Posts : 147
Join date : 2009-09-05
Age : 69
Location : Balbec Indiana
Re: ID for C6
whitefield February 10th 2014, 11:52 pm
4R100 transmissionhpwdboss1 wrote:Frank
So what has the steel 6 planet carrier been in? 'cause that's what is in mine now.
Perry
whitefield- Posts : 2244
Join date : 2009-08-23
Age : 56
Re: ID for C6
J.Toney February 11th 2014, 10:55 am
To be more specific, usually diesels. Although I've seen them in a few v-10 units, but someone else could've put them in during a build. It's nice to find OE, but the aftermarket is supplying them too.whitefield wrote:4R100 transmissionhpwdboss1 wrote:Frank
So what has the steel 6 planet carrier been in? 'cause that's what is in mine now.
Perry
J.Toney- Posts : 398
Join date : 2009-08-18
Location : Kent CIty, MI
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum