port mismatch mafia to p51
2 posters
Page 1 of 1
port mismatch mafia to p51
so i have this 598 with 10.7 compression,fully ported p51 heads,and a mafia intake.it had a victor on it but i was thinking to use mafia,but looking at the gasket to port mismatch i am not sure what to do.the victor has a similar mismatch as well.this is a drag car only.cam is 280-288 .787 lift.
so what have others done with there mafia? do they port match or leave it?see pics.gasket is a felpro 1231.
the heads
the victor
the mafia
so what have others done with there mafia? do they port match or leave it?see pics.gasket is a felpro 1231.
the heads
the victor
the mafia
hbstang- Posts : 365
Join date : 2012-10-29
Location : socal
Re: port mismatch mafia to p51
hbstang wrote:so i have this 598 with 10.7 compression,fully ported p51 heads,and a mafia intake.it had a victor on it but i was thinking to use mafia,but looking at the gasket to port mismatch i am not sure what to do.the victor has a similar mismatch as well.this is a drag car only.cam is 280-288 .787 lift.
so what have others done with there mafia? do they port match or leave it?see pics.gasket is a felpro 1231.
The ones I have done, It's almost a must to PORT match the roof and sides of runners 1,3,6,8 ... the roof of the others.
Mark Miller and nascar429 like this post
Similar topics
» My new TFS Raised Port Mafia R&D heads
» Square port intake vs oval port
» TFS Mafia
» Truck Mafia
» Double D Mafia..........
» Square port intake vs oval port
» TFS Mafia
» Truck Mafia
» Double D Mafia..........
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum