Ford Motorsport A460 Heads

I have a good set of used FMS A460 heads. I bought them to install on a motor that I'm putting together. However I didn't do my homework. My bore is 30 over with a fresh bore and new pistons. I was getting ready to install the heads so I started checking spring rates and noticed the the valves looked a little big. The intakes are 2.35 and the exhaust are 1.94. So they will not clear my bore and I had rather not go backwards installing smaller valves. So I have ordered a set of new Trickflow heads. The heads have a 66cc chamber on them. A light blending job on the ports. I have new (not installed) 7/16 plates and new rocker arm studs all from Trickflow. Asking $1500.00 plus shipping. I would prefer to have them picked up in person. There has been a small repair to the intake bolt area.

Location?

Lynn IN, 47355

Pictures?

J.Toney wrote:Pictures?

Sent you a PM

Hello, If these heads are still for sale could you send some pictures to me.

are the heads avaible ? 772-485-7516

Heads are no longer for sale