eliminator block

I am looking for an eliminator block that will sonic test as they advertise or atleast close to .200 at 4.700, I own one already but it sonic tested .164 on the thrust side at only 4.625 bore. I have sonic tested another elim. block and it was no better than the one i own. So i am looking for one that will go 4.700 and still be close to .200 thick as they advertise. Thanks

Have you contacted eliminator? see if they can hand pick you one? Chuck Steven's on here is a Dealer.

dfree383 wrote:Have you contacted eliminator? see if they can hand pick you one? Chuck Steven's on here is a Dealer.

far as I know raw block are finished to fill orders .

DanH wrote:

dfree383 wrote:Have you contacted eliminator? see if they can hand pick you one? Chuck Steven's on here is a Dealer.

far as I know raw block are finished to fill orders .

i am pretty sure you are correct Dan

ELIMINATOR blocks are finishes in small batches. Often times there are a few on the shelf. Other times there may be a small wait. I'll make a call to see if a pre shipping sonic check can be provided...and the cost.

That would be great, thank you very much.

chuck stevens i sent you a pm

Answered.

I spoke with mike from eliminator, and got what i was looking for! Thanks DanH and Chuck Stevens i appreciate the help! Dan i have been trying to reach you on the phone, give me a call. Thanks again for your help! Ragin' Cajun

Cajun, is your engine builder the guy in Louisiana that just bought all 4 of the in stock compacted graphite blocks?

yes sir.