BIG BLOCK FORD
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Convertor swap and c6 build

+2
cooter
manofmerc
6 posters

Page 2 of 2 Previous  1, 2

Go down

Convertor swap and c6 build  - Page 2 Empty Re: Convertor swap and c6 build

Post  res0rli9 March 1st 2012, 2:39 am

manofmerc wrote:I have cured my traction problems from my convertor swap.And now I love my ati convertor .Over the winter I bought a set of cal tracs,mono leaf springs,and rancho shocks .I bought them off this forum from 9 sec comet sight un seen .With a new set of slicks a change to 4.10 gears and my cal tracs and a freshed up 460 .I am in the 10s .Just barely lol! 10.99 .I have consistent 1.52 60 fts .This is without any tuning so far .I didnt have to much convertor .Just not enough rear suspension !Trans still ok .My 8" convertor is like a sledge hammer at the line .I might change out my rpm airgap to a victor to see what will happen .Time will tell Doug Cool

Good to see to see you got it all working. Whats the specs on the engine.
( Edit) found them. Cool

res0rli9
BBF CONTRIBUTOR
BBF CONTRIBUTOR

Posts : 3352
Join date : 2008-12-02
Age : 74
Location : sarasota FL.

Back to top Go down

Page 2 of 2 Previous  1, 2

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum