Thanks Induction Solutions..........

got my goodies installed tonight..............






Just some -6 lines, 1/4 turn valve and a press gauge my grandma could see, I made the little alum handle and mounting bracket for the valve.....................oh I might have some new jets someplace in there lol.

very nice Jon

what is the switch on the noid for ?

energizes the shifter noid

richter69 wrote:energizes the shifter noid

Shift it yourself...

one less thing to mess with................makes the car damn consistant also.

richter69 wrote:one less thing to mess with................makes the car damn consistant also.

Actually thinking about going that way myself...

nice to have both hands on the steering wheel..................

richter69 wrote:nice to have both hands on the steering wheel..................

Sometimes a guy can use both hands on the wheel!! Looks good!!

Nice clean job. I like it!

very clean!

yellowhorse7 wrote:

richter69 wrote:one less thing to mess with................makes the car damn consistant also.

Actually thinking about going that way myself...

I have a micro switch that the end of the solenoid plunger contacts on the back side and arms the circuit when I pull it back into low gear puts voltage to the solenoid. I also have a rocker switch that puts power to the micro switch. Probably not needed though.

richter69 wrote:one less thing to mess with................makes the car damn consistant also.

Methanol runs the same every pass no matter where you shift

IDT-572 wrote:

yellowhorse7 wrote:

richter69 wrote:one less thing to mess with................makes the car damn consistant also.

Actually thinking about going that way myself...

I have a micro switch that the end of the solenoid plunger contacts on the back side and arms the circuit when I pull it back into low gear puts voltage to the solenoid. I also have a rocker switch that puts power to the micro switch. Probably not needed though.

the snake setup is very slick, I just went the less sophisticated route and used a toggle switch lol.

I could have bracket raced this thing last friday night...............

Why didn't you??? Couldn't you use the money??

no bracket races friday night, and yes I got a check, and I spent some of it on the goodies in this thread............

Somebodies fancy.

Thanks you Sir !!! Nice install, looks great.. SJ

What's the 1/4 turn valve's purpose?

460bronco wrote:What's the 1/4 turn valve's purpose?

It will allow you to open the bottle valve up and monitor/maintain your nitrous pressure without nitrous or nitrous pressure against the solenoids. Then after your burnout you can SLOWLY open the valve and the system is now charged. Another great thing about having the 1/4 turn inline valve is in the event of an emergency you can close it quickly too.. So basically, safety and convenience. Thanks, SJ

worked very slick this past weekend....................I should have another package on the way soon from I/S...............

richter69 wrote:worked very slick this past weekend....................I should have another package on the way soon from I/S...............

GREAT TO HEAR !!! We greatly appreciate the support.. SJ

Got my care package last week too............. Thanks Steve.