528 CI MOTOR COMPLETE new price

528 ci motor.Forged steel Crankshaft Specialities,4.25 knife cut crank.Eagle 6.8 H beam steel rods.BRC domed pistons.
1970 block .080 over and filled.Full roller motor.CJ aluminum heads,with all titanium valves.Has main stud girdles.
Has rocker stud girdles.MotorSports valve covers.Victor intake with Pro Systems alchol dominator carb.
 .Aluminum Moroso water Pump and waterpump drive.Has Locked distributor with bronz gear.
Has high volume oil pump and pick up With f600 pan.Comes with front motor plate And flywheel.Ready to stick in and run.
Complete carb to pan. Has JW flywheel and Fluid damper balancer. GOOD MOTOR. $8000.00 plus shipping.

what kind of hp did it make?

If you use hp to et in my car had 750 @ REAR WHEELS. But depends on who's calc you use. Went 8.99 on throttle stop in 2500 lb chassis car.

THIS IS COMPLETE MOTOR READY TO RUN AND PRICED RIGHT.

You shure you guys are looking,This is a steal @ 8k complete.

Guess I will take offers or part out.I think if your looking for a good motor and you pass on this your crazy.It would be well over 13k to build it.Ran 8.80 @ 152 mph in 2550 lb chassis car.This isn't junk.full roller motor with all,thats 16 titanium valves.Dollar for dollar best motor on here.AMERICAN made steel forged crank,lightened and knife cut 2k new.

This is a deal! The heads would cost over half that 

Still the Best motor for the money on here.Can't believe it's not sold.

FUEL PUMP AND REGULATOR ARE NO LONGER WITH THIS MOTOR. MOTOR STILL FOR SALE

$6500.00 long block plus shipping. 

ttt

ttt

TTT

still for sale

BUMP

What a sweet deal   

still 4 sale can't believe no one has grabbed this up

still 4 sale

ttt  

What CR does it have?

If it wasn't hard blocked I think it would have gone by now. I am getting ready to build the same thing, but I need it to run constantly, not just short bursts.

bronco911 wrote:If it wasn't hard blocked I think it would have gone by now. I am getting ready to build the same thing, but I need it to run constantly, not just short bursts.

I wouldn't be opposed if needed. I haven't actually felt the NEED to fill a block, but know those that have. Dove block, half fill, 557", A-head. Served truck pull duty first 7800RPM. Then went to street, 10.5;1 and 6500 RPM. Dunes and to the lake 45 miles one way. Runs as cool as my 4.390 bore junk with NO fill. Just watch the oil temp, but nothing major.

That's what I was going to say. If worried about temp put an oil cooler on it. Looks like a good build.

You got a nice looking cobra jet motor.. And price is very fair , compared to building it..
I'm not thinking motors sell too good here... Been trying to sell a a 460 motor, n can't even sell for 10 grand... Heck, got around 7000 grand in heads...

Anyway, just wanted to wish u luck on ur sale .

Have a great day buddy,
Jason

BUMP