Am i on the right track?
3 posters
Page 1 of 1
Am i on the right track?
Broker her down this weekend bottom end looks great,
cam had a few lobes wiped out. The only other carnage was the rockers
The motors where a craigs list find,one bare dove a block and a complete dove-a block with a torker 2 intake, d3ve-a2a heads with rocker studs and guide plates.The headers and c6 where trashed ..being the bottom end looked really good I'm not wanting to tear into. But since the heads where off I was going to porting them add new springs and rockers,slap a baby cam like a comp 34-336-4.and let her eat.sound like an ok plan for now?
cam had a few lobes wiped out. The only other carnage was the rockers
The motors where a craigs list find,one bare dove a block and a complete dove-a block with a torker 2 intake, d3ve-a2a heads with rocker studs and guide plates.The headers and c6 where trashed ..being the bottom end looked really good I'm not wanting to tear into. But since the heads where off I was going to porting them add new springs and rockers,slap a baby cam like a comp 34-336-4.and let her eat.sound like an ok plan for now?
Sausage- Posts : 11
Join date : 2015-02-20
Re: Am i on the right track?
Id pull it down and check the bearings and clean everything. Looks like it might if had some detonation going on.
dfree383- BBF CONTRIBUTOR
- Posts : 14846
Join date : 2009-07-09
Location : Home Wif Da Wife.....
Re: Am i on the right track?
dfree383 wrote:Id pull it down and check the bearings and clean everything. Looks like it might if had some detonation going on.
I agree,clean everything simply because the cam wiped and it needs it.And yes it has been burning abit lean.
bbf-falcon- Posts : 8995
Join date : 2008-12-03
Location : Jackson, Ohio
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|