BIG BLOCK FORD
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Question about Morel .936 keyway lifters

2 posters

Go down

Question about Morel .936 keyway lifters Empty Question about Morel .936 keyway lifters

Post  nathan mann July 30th 2015, 5:03 pm

Are all morel .936 key way lifters the same? If so will a set of nascar pullout lifters work in a Eliminator ultra block if it is machined for these types of lifters? Who would be a good person to take this to and have the block the machining done?

nathan mann

Posts : 38
Join date : 2010-10-18
Age : 49
Location : little rock arkansas

Back to top Go down

Question about Morel .936 keyway lifters Empty Re: Question about Morel .936 keyway lifters

Post  Curt July 30th 2015, 7:11 pm

nathan mann wrote:Are all morel .936 key way lifters the same? If so will a set of nascar pullout lifters work in a Eliminator ultra block if it is machined for these types of lifters? Who would be a good person to take this to and  have the block the machining done?
Keith Craft could probably do it. They probably won't assemble it since the lifters are used. Depending on the heads you have, the offsets might not be optimal if they are offset at all.
Curt
Curt

Posts : 2791
Join date : 2009-02-08
Age : 62
Location : Henrietta, Texas but mostly on the road

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum