BIG BLOCK FORD
Would you like to react to this message? Create an account in a few clicks or log in to continue.

If it wasn't for bad luck

+2
supervel45
gmsmkr
6 posters

Go down

If it wasn't for bad luck Empty If it wasn't for bad luck

Post  gmsmkr November 21st 2015, 12:23 pm

We loaded up at 9pm last night after some changes to the small block car get to the track unload about 10pm. Running around in the pits to get everything warm and driver front strut takes a shit fender on top of tire car suddenly don't want to run spitting and bucking.... unload this morn strut is back up to ride height and car runs perfect Rolling Eyes

Any body feel my pain
gmsmkr
gmsmkr

Posts : 1364
Join date : 2014-06-22
Location : alabama

Back to top Go down

If it wasn't for bad luck Empty Re: If it wasn't for bad luck

Post  supervel45 November 21st 2015, 2:09 pm


That's not a good Omen.

supervel45

Posts : 4499
Join date : 2013-09-04

Back to top Go down

If it wasn't for bad luck Empty Re: If it wasn't for bad luck

Post  billandlori November 21st 2015, 3:08 pm

Those intermittent problems are a PITA!!!

We chased a high RPM miss in my buddy's altered for a whole year. We replaced everything, tried to swap in known good parts etc. It just went away, we never knew what fixed it!!

Bill
billandlori
billandlori

Posts : 2081
Join date : 2009-08-06
Age : 55
Location : Stratford, Ontario, Canada

Back to top Go down

If it wasn't for bad luck Empty Re: If it wasn't for bad luck

Post  Larry T November 21st 2015, 10:36 pm

yep a friend has a new procharger small block set up it ran perfect until he went to Knoxville 3 weeks ago.out of the trailer it didn run rite so he lost everything it cost to get in to race etc no refunds.anyway he never did figure out what the problem was last sunday off the trailer it went the fastest it has ever ran.now figure that out Shocked
Larry T
Larry T

Posts : 1076
Join date : 2009-01-08
Location : leicester,NC

Back to top Go down

If it wasn't for bad luck Empty Re: If it wasn't for bad luck

Post  FalconEh November 22nd 2015, 8:06 pm

Mike,
Make sure when you tie the car on the trailer you don't bottom the suspension, it can stick if you do. You can use a block of wood as a limiter.
FalconEh
FalconEh

Posts : 1448
Join date : 2014-08-21
Location : on the blacktop or in the mountains ????

Back to top Go down

If it wasn't for bad luck Empty Re: If it wasn't for bad luck

Post  gmsmkr November 23rd 2015, 7:50 pm

We got it fixed sat night it was struts for some reason it was holding the front end down Shocked

Sounds like you guys have had some crazy stuff happening also..
gmsmkr
gmsmkr

Posts : 1364
Join date : 2014-06-22
Location : alabama

Back to top Go down

If it wasn't for bad luck Empty Dont feel bad I got it too

Post  manofmerc November 25th 2015, 6:52 am

After getting my 6al issues corrected I worked about a week getting a new shifter installed along with wiring in my trans brake .Well it doesn't work I have been on the phone trying to troubleshoot it .Yesterday the builder says ship it back to him .I thought this would be a somewhat simple installation .NOT.Good luck Mike ! Doug Sad

manofmerc
BBF CONTRIBUTOR
BBF CONTRIBUTOR

Posts : 564
Join date : 2011-03-31

Back to top Go down

If it wasn't for bad luck Empty Re: If it wasn't for bad luck

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum