What luck!!

Looks like when this faulty ignition switch was cutting in and out at full throttle and split the cylinder in my engine, it also bent the crank? Now it looks like I'm going to need a crank and a piston too.....what a F%%^&^%king year this has been so far!!!

Dang it all Dan. You just keep winning the bad luck over and over again.

Damn man....you are on a roll.
They say bad things come in three's....maybe things will turn around now.

Damn Dan that sucks. Hopefully all the bad luck is gone now, let me know if you need anything.

Damn ...sory to hear Dan ...why dont you take off a couple of weeks and visit and relax

Check the rods for straight too.

Man that sucks maybe its because you had to hog that King Thing tital for TWO YEARS i mean that was cold ya know....nuthing like rubbin it in a little

bruno wrote:Damn ...sorry to hear Dan ...why don't you take off a couple of weeks and visit and relax

yea what bruno say's! You keep fixing stuff at this rate, your going to get under azz kicking size and then people are going to start slapping you around slim!!

Race Ready Fabrications wrote:Damn Dan that sucks. Hopefully all the bad luck is gone now, let me know if you need anything.

Read his post, I think it is a crank, and piston. j/k

It has to get better Dano,cause it can't get a whole lot worse I got that 514 assembly here if ya need it

Treeyasoon wrote:Damn man....you are on a roll.
They say bad things come in three's....maybe things will turn around now.

Threes? This is like, eleventeen, isn't it?

I dont mean this in a negative way, but that thing would be gone if I had this many fits with it....................sorta takes the "fun" out of it after awhile.

Sorry for your troubles Dan-O.

what kinda crank you got that bent? that's gotta suck,sorry for you Dan.

It's a Scat 4340 4.5" stroke.....I'll know the 1st of the week if it's repairable..It's getting old Fabio...but if I survive all this ,there will be some good things on the other side of this MOUNTAIN Hell if it was easy everyone would do it

Damn your lucks sucks Dan. Sorry to hear about more problems.

Just trying to cheer ya up a little, hope you get it up and running soon.

Dang it Dan. You are a better man than me. Sometimes I need to step back and say screw it for a while but then the juices get flowing again and I am back in the shop. I am getting real close to being burnt out myself with this new engine stuff.

I ALWAYS run out of money before patience. GitRdone Dan

How many passes on the motor since the sleeve was put in? Is it bent on the same cyl the cyl cracked?