Making your own gaskets
3 posters
Page 1 of 1
Making your own gaskets
JBR-3 June 15th 2019, 4:04 pm
.
Last edited by JBR-3 on October 17th 2020, 2:59 pm; edited 1 time in total (Reason for editing : .)
JBR-3- Posts : 266
Join date : 2009-08-17
Re: Making your own gaskets
rmcomprandy June 15th 2019, 5:56 pm
JBR-3 wrote:What are people using to make their own intake manifold gaskets ?
How about header gasket material too ?
Fel-Pro offers blank intake gasket material for cutting your own intake gaskets.
rmcomprandy- Posts : 6157
Join date : 2008-12-02
Location : Roseville, Michigan -
Re: Making your own gaskets
Curt June 17th 2019, 11:37 am
Ball pein hammerJBR-3 wrote:What are people using to make their own intake manifold gaskets ?
RTV red.JBR-s wrote:How about header gasket material too ?
Curt- Posts : 2791
Join date : 2009-02-08
Age : 62
Location : Henrietta, Texas but mostly on the road
Re: Making your own gaskets
JBR-3 June 17th 2019, 9:59 pm
.
Last edited by JBR-3 on October 17th 2020, 3:00 pm; edited 1 time in total (Reason for editing : .)
JBR-3- Posts : 266
Join date : 2009-08-17
Re: Making your own gaskets
Curt June 19th 2019, 10:46 pm
JBR-3 wrote:Curt, no gasket per se, just a thin schmear of the high temp RTV ?
Just enough to make a gasket. No need to close an exhaust port.
Curt- Posts : 2791
Join date : 2009-02-08
Age : 62
Location : Henrietta, Texas but mostly on the road
Similar topics» Timing Pointer for Stock Timing Cover
» how much hp do you guys think my 466 is making?
» Making this a better tow truck
» Making a oil priming shaft.
» Won't be making it to the bash
» how much hp do you guys think my 466 is making?
» Making this a better tow truck
» Making a oil priming shaft.
» Won't be making it to the bash
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum